Layered Valance


Hey there! It's Rebecca Silbaugh from Ruby Blue Quilting Studio, back for another recipe! This time around I have for you a tutorial on how to make your own valances. I was looking for the perfect curtains to match the new paint in my sewing room. And let me tell you, after searching and searching I finally got fed up enough that I decided to make my own. Now I can coordinate my window treatments with any quilts I decide to display. Here's what you'll need to get started:




One jelly roll (I used Oasis by 3 Sisters - Very Yummy!!!)
One Yard of main fabric for pleated layers (I used #4044 11)
1/4 Yard of an accent fabric (I used the pink #4048 13)

Depending on the size of your windows and the number of valances you would like to make, you may need to alter the amounts of fabric needed. We'll discuss this more in a minute.


I added some buttons onto my valance where the pleats meet, but you could also add ric rac, pom poms, lace, or any other kind of trim you desire. Applique would be adorable as well!


Don't say I didn't warn you, but this recipe does call for some math (just a smidge, not a bunch). To get started, you will need to measure the hardware for where your valance(s) will hang. First measure the width of the hanger and if it's a curved piece like mine, you will need to measure the sides too.


Alright, here's the incy wincy amount of math needed. Take the measurements:
(side x width x side = total width)

For example my window measurements are : 2.5" x 49" x 2.5" = 54"

To calculate how many jelly roll strips you will need, take the total width and divide by 2. (54" / 2 = 27).
I will need to choose 27 strips to get the width to cover my window.


Take those 27 strips and lay them out until you get a pleasing assortment that mixes the colors. Sew the strips together.

Once sewn, you will need to trim off the selvage edges to make a straight square edge.


Also, trim off 2 strips 5" wide and set these aside for now.


Fold the remaining strip set in half, right sides together. It should now measure roughly 15" x the calculated width. Pin the edges if needed.


Sew along the edge stitching all the way to the fold. Repeat for both sides.


Trim the corner. Do not cut through your stitching! Fold the piece inside out and press. If you need to finagle (technical term for fudge) your seams to the edge and pin them in place until you press, you can do so if it helps. Top stitch around all 3 closed edges. Do not topstitch the open side!


From your Main Fabric, cut 2 strips 2.5" wide and set aside. Cut the remaining fabric into equal halves, approximately 15" wide x WOF each.

Now, look back at your window measurements - you'll need those once again. Just a smidgen more of math, promise!

If you have sides to your window hardware, take that measurement and add 1/2" to it. (2.5" + .5" = 3") Cut a strip the width of this measurement from each of the 2 larger Main Fabric pieces. ( 3" x 15").

Then take the straight width measurement of your window and divide by 2. (49" / 2 = 24.5"). Add 1/2" to that calculation to get the measurement of the to front pleats needed. (24.5" + .5" = 25") Now cut a segment the length of this measurement from each of your 15" pieces. (25" x 15")


Fold each of the pieces just cut in half right sides together so they're only 7.5" x measurements from above. Stitch along the two 7.5" edges on each piece, trim the corner fabric, turn right sides out and press. Then topstitch as you did with the larger pieces strip segment for each of these pieces. Set aside.


Now cut 2 strips 2.5" wide from your accent fabric. Sew these two strips together into one long 2.5" wide strip.

* Depending on your hardware, if you have a decorative end that may be larger than 2" tall, you may need to adjust this measurement to make sure your valance will fit onto the hardware.


Sew the accent strip onto one of the 5" wide strips cut from the jelly roll segment. Trim any excess so the accent is the same length as the jelly roll strip.


Fold the strip in half right sides together and only stitch from the seam to the fold. Do this on both ends. Trim the corners, and fold right sides out. While pressing, make sure the un-stitched areas of each end are folded in and pressed to match the sewn areas.

Topstitch only the sewn parts of this piece stitching along the top (folded) edge, the two sides, and stitching in the ditch (along the seam) of the accent fabric. (Stitching in the ditch along the accent fabric seam will form the pocket for the window hardware, don't forget this step although I missed getting a picture of it somehow, I apologize. I must have just been in the groove and sewing away!)


Now this part is a bit tricky, but just remember to breathe and go slowly. You'll be fine. Top stitch the folded seams where the arrow shows. You will need to do this for all four seams (2 per end), this will enclose the seams and then your hardware won't catch on it while you're attempting to hang your valance.


 Remember those 2.5" strips from the Main Fabric? Sew those together forming one long 2.5" strip.


Trim the selvage off one edge and fold over wrong sides together 1/2" and press. Fold the raw edge into the crease and press again for a double 1/4" hem. Topstitch the edge as shown. Measure the width of your jelly roll piece to be sure and add .5". Trim the 2.5" wide strip to that measurement and fold in the opposite end and topstitch as you did with the first one.


Now comes the fun part. Time to layer! Layout your jelly roll strip with raw edges opposite you.


Next lay the main fabric pleats, 2 larger pieces in the center and 2 smaller pieces on the outsides. Align the raw edges from these with the raw edges of the jelly roll strip.

(If there's a small gap in between the pieces that's fine, just don't overlap these pieces!)


Place the 2.5" main fabric strip on top of these right side down and pin all the pieces together aligning the edges. Press the 2.5" main fabric strip up.


Now place the smaller jelly roll and accent piece onto the valance aligning the raw edges and making sure the accent piece is going to be touching the main fabric.


Pin in place and press. The valance is done, but...


Remember that other 5" strip from back in the beginning? If you have longer curtains you are going to be putting in the same window, you could use this strip for coordinating tie-backs. Press the strip in half wrong sides together.


Open it up to see the crease.


Press one side over to the crease.


Press the opposite side to meet the first at the crease.


Press in half where you originally had it at the crease, enclosing all edges. And pin if needed. Trim in half and topstitch. If you want to fold in the edges to finish them off, do so before topstitching. Or if you have pinking shears, use those to trim the pieces in half to bet the same effect as the jelly roll edges.



One valance, approximately 20" long and covering the width of your window with pleats at each corner and the center. Add buttons or any other embellishments you'd like before you hang it up, I put a button at each pleat.


This is what it looks like during the day with the sun shining, it almost gives it a stained glass window feel.

Or at night, the colors still show off beautifully.


This is the view of my sewing room where it hangs. Please don't mind the mess, it's just a sign of works in progress and once I get the perfect lace curtains, the coordinating tie backs will look wonderful.

I hope you like this recipe and if you have any questions or would like help on how to figure out what you will need to fit your windows, please e-mail me at rubybluequilts (at) gmail (dot) com.

I also have made some other curtains for my house as of late, so hop on over for tutorials on those and to see what else I might be cooking up at my blog, rubybluequilts.blogspot.com.

As always, I would love to see your version  of this recipe so e-mail it to me and I will post it on my blog or add it to the Moda Bake Shop Flickr Group!

Until next time!

-Rebecca Silbaugh

24 comments:

Linda said...

Very pretty! Great idea!

Quiltjane said...

Very unique and stylish. 3 Sisters have done it again with gorgeous pastels.

Gabriela López García said...

Lovely! Thank you.

Darlene Gerber said...

Becky nice job once again!!!

Monika said...

Great idea!!! Thank you!

Jo said...

I need a curtain in my sewing room too. This just might be the one!

Cindy said...

I HEART this valance !! Perfect for the sewing room - or ANY room to bring out the 'quilter' in all of us.

Great job !!

Wendy said...

"2.5" x 49" x 2.5" = 54""
should those be plus signs?

fantastic project. I love the stripes, and it's a gorgeous way to show off beautiful fabric in any room!

Ruby Blue Quilting Studio said...

Hahahaha!!! I swear you proof read and proof read and something like this slips through!

Wendy, yes those are supposed to be plus signs, sorry about the mix up.

Thanks for all of the lovely comments!!!

The Tulip Patch said...

This is BEAUTIFUL. I WILL be using this. Now just to find the perfect fabric and I am set!

asnipofgoodness said...

that is fantastic, so very pretty! It does look like a ton of work, but I must say, well worth it for the finished product. Keep up the terrific work Moda Bake Shop, we love your ideas!

Karen said...

I love this. I have made all my own valances for years, but have wanted a new one for my office/sewing room and now I have found the perfect touch! Great idea!

JessicaSews said...

Love this project!
Thank you for sharing!

eamylove said...

Great project, beautifully done. I'm off to your blog now, to see more window dressing. I love the home dec projects on MBS so much!

FabricsNQuilts said...

LOVE this!

mgibson444 said...

What an adorable valance! Don't you just love those JellyRolls??
Great idea, thanks.

julie reynolds said...

very nice. love the colors and the layered look...plan to refinishe my kitchen soon

simonepatch said...

Lindoooooooo.As cores ficaram muito bem combinadas a o Bandô ficou muito charmoso.Beijoss

simone.poa

www.simonert.blogspot.com

Debbie kelly said...

this is a great valance for my new sewing room!!! I have these fabrics also. My theme is going to be pink and white when room is finished next fall. Thanks

Pam said...

I made 2 of these to match Line Art quilts for 2 little girls. Great pattern! They loved their matching window treatments and I enjoyed making them. Thanks

Carol Mannheim said...

I just found this project. I am so excited. Now I know what to do with the jelly roll and yardage my friend gave me. It will look great in my studio/sewing room. Thanks so much for sharing.

Waseem said...

Beautifully done...like the way nice fabric in the room...look so fantastic.

Roman shades concord, ca

Michelle Smith said...

The layered Valance shown here is marvellous. The post is very good

Wallcoverings

Vivek Sharma said...

The layered valance shown here is excellent. Know details from here

Sofa Cum Beds