NIOSA Quilt

 

NIOSA - Moda Main Image

Hi y’all!  It’s Cathy Smith again from over at A Quilting Chick.  I’m so excited to be back at Moda Bake Shop sharing my newest pattern design, NIOSA. NIOSA (N-eye-O-sah) is Night in Old San Antonio. During Fiesta, I was inspired by all of the bright, fun colors of the piñatas and cascarones that hail in Spring in San Antonio. I started playing around with sawtooth stars and came up with these fun, bright blocks. They remind me of the fun colors of Fiesta on a night sky, thus NIOSA.

This quilt/project finishes at 94″ x 94″.

8cb62-title_ingredients

1 Fat Quarter Bundle (Good Karma by Stephanie Ryan) Use as many as you’d like for variety but you can get what you need from 17 fat quarters
6 yards background fabric (Bella Solids Royal 9900-19)
9 yards backing fabric
1 yard binding fabric

96b91-title_instructions

Cutting Instructions

  1. From the background fabric, cut (50) 7-1/4” squares, and (200) 3-1/2” squares.
  1. From each fat quarter, (3) 6-1/2” squares, and (12) 3-7/8” squares. Draw a diagonal line on the back of each of the 3-7/8” squares.  Keep the fabrics sorted by fat quarter.
  1. Cut (3) 24-5/8″ squares of your background fabric.  Cut each on the diagonal twice (in an “x” fashion).  Set aside for your side setting triangles.
  1. Cut 2 (for all sizes) 12-5/8” squares of your background fabric. Cut ONCE on the diagonal.  Set aside for your corner setting triangles.

1 - Cutting

Sewing Instructions

All sewing instructions assume a scant 1/4″ seam allowance.  We will be making (50) sawtooth stars.  The following directions are to make ONE star.  Repeat to make all 50 stars.

      1. Place (2) 3-7/8” squares on top of (1) 7-1/4” square, right sides together, as shown.  The center corners will overlap.  Pin as shown. 2 - Pinning Flying Geese
      2. Sew a scant 1/4” seam on each side of the diagonal line as shown.3 - Flying Geese Sewing 1
      3. Cut on your drawn diagonal line and press open.  You will have two pieces that look like the picture to the right.4 - Cutting Flying Geese
      4. Pin a 3-7/8” square to the corner of your partial flying geese.  Pin as shown.  Repeat for both of the partial flying geese pieces.5 - Flying Geese Pinning 2
      5. Sew a scant quarter inch seam on both sides of your drawn line, as shown.6 - Flying Geese Sewing 2
      6. Cut on your drawn line and press open.  You will now have 4 flying geese units.  Square up to 3-1/2 x 6-1/2”. 7 - NIOSA Flying Geese
      7. Arrange (4) flying geese units with (1) matching 6-1/2” square and (4) 3-1/2” background squares as shown.  Sew into three rows.  Press seams away from the flying geese units.8 - Sawtooth Star Layout
      8. Layer the top and bottom row over the middle row as shown.  Pin along the long edges and sew.9 - Sewing Sawtooth 2
      9. Press open. You’ve now completed your sawtooth star!  Remember, you need to repeat these instructions to make (50) stars.10 - Sawtooth Complete
      10. Next, go through and pair up your stars.  You don’t want them to be too “matchy” so don’t pair up two greens or two blues.  Mix it up.
      11. Now this is the hard part.  It literally made me wince when doing it.  But you CAN do it!  We’re going to cut those pretty sawtooth stars.  Line one of your stars up on your cutting board, using the 45-degree angle line as your guide (see picture).11 - Cutting Sawtooth 1
      12. Now…cut.  You will get two halves, as shown.  Repeat with your matched star.12 - Cutting Sawtooth 2
      13. Rearrange your halves as shown.  This is your final block layout.13 - Block layout
      14. Flip the top, right halves onto the lower, left halves, right sides together and pin as shown.14 - Block Pinning
      15. Sew the pieces together then join the new halves into the whole block.  Be careful when sewing your center seam; you will be sewing on a bias edge.  Pin well and don’t pull it through the machine.  Just let if feed through.  Press open.  Repeat with all matched pairs.  Your unfinished blocks will measure 17″.NIOSA - Finished Block
      16. Now it’s time to arrange your blocks!!!  We are setting this on point (see diagram).  Your setting size is listed in the fabric requirements chart.  Using your corner and side triangles, sew your quilt top together!15 - On Point Diagram


4b2da-title_yield

Makes one (1) 94″ x 94″ quilt top.  Layer with batting and backing and quilt as desired.

NIOSA Bench pic

I sure hope that you give this one a try!  It looks a lot harder than it is and I enjoyed making it so much! My son is campaigning hard for this one!  And if I’m honest, it just screams his name. Where will yours go?  Don’t you know someone that will love it?  I hope you enjoy making NIOSA.  Please feel free to stop by my blog and join in the fun!

Cathy Smith
{aquiltingchick.blogspot.com}

JOIN THE CONVERSATION
Email this to someoneShare on FacebookTweet about this on TwitterPin on PinterestShare on LinkedInShare on Google+

9 comments on “NIOSA Quilt

  1. Lisa Calle says:

    Cathy, this is so so gorgeous! Fun pattern and fantastic color choice with that bold blue background.

  2. Sally says:

    Love how it draws your eye to different shapes…first the stars stand out…then the squares did…wonderful!

  3. Katy says:

    I love the colors and the pattern

  4. kathyinmn says:

    All that work to make star blocks and whack-cut them in half. LOL, and it looks great. Beautiful pattern. Nice visuals on the flying geese blocks.

  5. My eye immediately picked up the split stars and I was hooked with the royal background! Gorgeous and unique quilt design with a very clear tutorial! Thanks! I love it!

  6. Susan says:

    I really like the different way the blocks are put together!

  7. It is beautiful! Courageous woman – cutting those beautiful stars! But I think I am going to follow your lead! 🙂

  8. Petra says:

    I am stunned!! I simply love this. I really want to make this one!!

Comments are closed.